Some brackets might say if they’re meant specifically for MDF, but it’s more important to check that any brackets you use can support the weight of the board. MDF boards can be over 50 pounds (23 kg). Any product that can hold enough weight will work. Check the board’s weight by weighing yourself, then weighing yourself again holding the board. Subtract the first number from the second number to get the board’s weight. These sets should come with 2 brackets, 1 for the board and 1 for the wall, and any screws or other hardware you need. If they don’t, use wood screws 1⁄2 in (1. 3 cm) long.
If the board is 10 inches (25 cm) wide, 10 divided in half is 5. Put a mark at the 5 in (13 cm) point.
If you’re using 1⁄2 in (1. 3 cm) screws, then drill pilot holes that deep. Try holding the screw against the drill bit for a reference on how far you should drill. Don’t drill holes closer than 1 inch (2. 5 cm) from the edge of the board. MDF edges are weak and the board could splinter or break under the weight. The board will be strong enough in any spots that are at least 1 inch (2. 5 cm) from the edge. You should always pre-drill any kind of material before drilling it, whether it’s MDF, wood, or plastic.
Don’t try to hang MDF without finding a stud. It’s too heavy for regular drywall to hold. [6] X Research source You can also find a stud by tapping on the wall. A hollow sound means that there is no stud in that spot, and a solid sound means you found one. If you’re mounting the board on brick or concrete, don’t worry about finding a stud. The masonry will support the board’s weight.
If you’re attaching the bracket to brick or concrete, use a masonry drill bit and screws so they don’t break. Drill pilot holes first, then hold up the bracket and insert the screws. [8] X Research source
Removing screws is easy. Just run the drill in reverse. You can fill old drill holes with spackle and repaint them, or just let the board cover them.
Since the MDF board is so heavy, you might need someone to help you lift it. Let go of the board slowly so you know that the bracket is supporting it.
