Plastic spoons can be hard to cut, so ask for help if you need it. Be careful cutting the plastic spoons as the pieces can fly off when you cut them.
Check the diameter around the circle to make sure it’s even. The sheet of styrofoam should be at least 2 inches (5. 1 cm) thick. Place the styrofoam on a surface that you don’t mind cutting, like cardboard or a cutting block, in case the utility knife cuts through the styrofoam.
Use standard 9 in (23 cm) paper plates.
It may take some effort to push the skewer through the styrofoam and plates. But be careful not to place your hand over the center of the plates and styrofoam to avoid poking yourself with the skewer.
Allow the glue to dry for at least 1 hour before you move on so the glue is completely set.
You can place a dab of glue at the hole where the skewer goes through to anchor it into the plate and styrofoam. [7] X Research source
Play around with making the wheel spin faster or slower by pouring more or less water over the spoons to alter the speed.
The foam board should be a minimum of 24 inches (61 cm) long and 3⁄16 inch (0. 48 cm) thick.
You may want to place cardboard beneath the foam board or cut on a surface that you don’t mind cutting in case the knife cuts through the board.
Make sure all of the paddles are facing the same direction!
Check that the glue is dry by pressing against the sides to make sure they don’t wobble.
It can help to rotate the skewer as you press to push it through the board.
Take the first “A” frame and use it to trace your second frame so they are the same size.
Let the glue dry for another hour before you do anything else so the stand is sturdy and secure.
Adjust the flow of the faucet to speed up or slow down the spinning wheel.
